ISO-CONNECT OUTSIDE CX
Product description |
Product advantages |
||
|
ISO-CONNECT OUTSIDE CX is a special foil sealant which is air tight and impermeable to driving rain for connecting joints on
in accordance to the new energy saving regulation (EnEV) requirements. It consists of a water vapour diffusion permeable synthetic fleece with a self adhesive strip on one edge for a quick and effective application on window frames. After installation ISO-CONNECT OUTSIDE CX can be plastered over. |
|
||
Applications |
|||
Service |
|||
| ISO-CONNECT OUTSIDE CX is used to seal external connecting joints, for weather protection in areas where vapour diffusion permeability is required. It allows trapped moisture in building joints to escape, according to the RAL installation guidlines, avoiding damage caused through condensation. ISO-CONNECT OUTSIDE CX is highly flexible, which aids exact application, particularly around corners. It also allows the optimum bonding of wet plaster, render etc. (without the need of a primer), and is extremely suitable as a base for thermal insulation materials applied to external facades. |
|
| Technical data | Standard | Classification |
| Material description | vapour diffusion permeable synthetic fleece | |
| Colour | white | |
| Weight | 200 – 250 g/m² | |
| Impermeable to driving rain | DIN EN 1027 | ≥ 1050 Pa |
| Air permeability coefficient | DIN EN 1026 | a ≤ 0,1 m³/[h*m*(daPa)ⁿ] |
| UV light stability | approximately 3 months | |
| Temperature stability range | internal | approximately -40°C to +100°C |
| sd-value | DIN EN ISO 12572 | approximately 0,05 m |
| Flexibility at -23°C | internal | no breaks, no tears |
| Fire behaviour | DIN 13501 | E |
| Dimension tolerance | DIN 7715 T5 P3 | requirements fulfilled |
| Shelf life | 1 year, dry and in original packing | |
| Storage temperature | +1°C to +20°C |
Application |
Finishes |
|
|
The bonding surfaces must be firm, dry, clean from dust, stripping agents, solvents, oil and fat. When sealing windows, panels and door frames remove backing from the self-adhesive strip, then lay the foil onto the surface and press securely. ISO-CONNECT OUTSIDE CX can be applied in the factory. For the wall applications ISO-TOP FLEX-ADHESIVE SP or SP+ is used. Normal rough, e.g. uneven wall surfaces, can be compensated for through the application of a sufficient amount of adhesive. Use sufficient adhesive so that after applying the foil the adhesive caterpillar is at least 30 mm wide and 1 mm thick. On areas that are to be plastered over a continuous „Z“ shaped caterpillar should be applied over the area. Overlapping of the foil ends should only be up to 50 mm wide using the same technique. Plastering can be done as soon as the adhesive bond is enough to carry the plaster. |
Single side self-adhesive with 1 self-adhesive strip. Special finishes available upon request. | |
Dimensions |
||
| Width: 70, 90, 145, 180, 235, 290 mm. | ||
Packaging |
||
| Rolls, roll length: 30 m. | ||
 |
 |
|
| Product Data Sheet |