ISO-CONNECT INSIDE CX
Product description |
Product advantages |
||
|
ISO-CONNECT INSIDE CX is a special water resistant and vapour diffusion impermeable foil for an air tight and wind proof sealant on connecting joints in
in accordance to the new energy saving regulation (EnEV) requirements. It consists of a synthetic fleece with a self adhesive strip on one edge for a quick and effective application on window frames. |
|
||
Applications |
|||
Service |
|||
| ISO-CONNECT INSIDE CX is used to seal internal connecting joints. Due to its large sd-value it is suitable for sealing joints where an impermeable vapour diffusion, and airtight, seal is required, separating the internal and external air conditions. ISO-CONNECT INSIDE CX is highly flexible, which aids exact application, particularly around corners. It also allows the optimum bonding of wet plaster, paint, etc. (without the need of a primer), and is extremely suitable as a base for thermal insulation materials applied to internal facades. |
|
| Technical data | Standard | Classification |
| Material description | vapour diffusion impermeable synthetic fleece | |
| Colour | grey | |
| Weight | 250 – 300 g/m² | |
| Impermeable to driving rain | DIN EN 1027 | ≥ 1050 Pa |
| Air permeability coefficient | DIN EN 1026 | a ≤ 0,1 m³/[h*m*(daPa)ⁿ] |
| UV light stability | approximately 3 months | |
| Temperature stability range | internal | -40°C to +100°C |
| sd-value | DIN EN ISO 12572 | approximately 40 m |
| Flexibility at -23°C | internal | no breaks, no tears |
| Fire behaviour | DIN 13501 | E |
| Dimension tolerance | DIN 7715 T5 P3 | requirements fulfilled |
| Shelf life | 1 year, dry and in original packing | |
| Storage temperature | +1°C to +20°C |
Processing |
Finishes |
|
|
The bonding surfaces must be firm, dry, clean from dust, stripping agents, solvents, oil and grease. When sealing windows, panels and door frames remove backing from the self-adhesive strip, then lay the foil onto the surface and press securely. ISO-CONNECT INSIDE CX can be applied in the factory. For wall applications ISO-TOP FLEX-ADHESIVE SP or SP+ is used. Normal rough, e.g. uneven wall surfaces, can be compensated for by the application of sufficient adhesive. Use enough adhesive so that after applying the foil the adhesive caterpillar is at least 30 mm wide and 1 mm thick. On areas that are to be plastered over a continuous „Z“ shaped caterpillar should be applied over the area. Depending on the μ-values of the surface it can be necessary to increase the width of the adhesive caterpillar up to > 50 mm, in order to reduce the water vapour permeability. Overlapping of the foil ends should only be up to 50 mm wide using the same technique. Plastering can be done as soon as the adhesive bond is enough to carry the plaster. |
Single side self-adhesive with 1 self-adhesive strip. Special finishes available upon request. | |
Dimensions |
||
| Width: 70, 90, 145, 180, 235, 290 mm. | ||
Packaging |
||
| Rolls, roll length: 30 m. | ||
 |
 |
|
| Product Data Sheet |